Remote manual for direct tv

To reset all the functions of the remote control to the factory default settings following these steps:. The old remote Genie will still. Look at the upper left of the remote for its model number. Press and hold mute and select wait 4 flashes Thats factory reset. Pres and hold mute and enter wait for flahes then channel up this will pair rf mode. Also the holding of mute and enter will too. Step 2: Enter 9 6 1. Step 3: Press and release 'Channel Up'.

The green light will flash twice. Step 3: Press and release 'Channel Down'. Locate the reset button. This is a small red button located inside the access card door, or, on some models, on the side of the receiver. No button? Go to step 3. Push the button. Wait 15 seconds. Go to step 4.

Unplug your receiver from the wall outlet. Wait 15 seconds, then plug it back in. Try your remote. Even the glass door on your entertainment center can cause interference. Keep your receiver and remote out of direct sunlight. Also, try turning down the brightness on your TV. First, which remote do you have?

Find them by using this code lookup tool. Follow the on-screen prompts to complete the process. Slide the mode switch located at the top of the remote to TV. Hold down the Mute and Select buttons at the same time. Let go when the green light flashes twice. Enter The green light should flash twice again. While you continue to aim the remote at your device, hold down the Mute and Enter buttons. Press Menu on the remote.